Caterham Seven User Manual download pdf (Page 108)

Page | 107

engine. It enables the engine oil to be

cooled by circulating coolant around the

oil-filled modine cooler.

Figure 79: Location of modine

Position the breather bottle mounting

bracket on the chassis as shown in the

picture. Align the RHS hole on the bracket

with the RHS rivet on the chassis and

mark both hole. Drill the marked hole with

5/32” drill and fit the bracket in place using

5/32 rivets refer to fig 80. Push fit the

breather bottle on to the mounting

bracket.

Figure 80: Breather bottle mounting

bracket

Position a hose clip on the flexible bottom

radiator hose, apply rubber lubricant and

fit the hose to the larger of the two outlets

on the LH side of the engine block, Refer

to Fig 81. The hose passes forwards

along the LH side of the engine bay

before turning to pass along the top of the

steering rack and turns again to meet the

radiator connection. Do not tighten the

clip.

Figure 81: Bottom radiator hose engine

connection (view from top)

1. Small straight hose to ‘T’ piece

2. Bottom radiator hose

Fit the four rubber radiator mountings to

the front of the chassis and secure using

nuts, plain washer and spring

washers provided in the cooling pack.

Warning

Do not over tighten the blanking plug.

The blanking plug is already fitted to the

radiator, make sure it is tight. Fit the

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 226 227

Comments to this Manuals

No comments