Page | 158
the bolt into the harness mounting point,
refer to Figure 144.
Figure 143: Shoulder strap with track
day roll over bar
To fit the outboard lap strap, assemble
a 7/16" UNF x 1" bolt, with a plain washer
next to the bolt head, pass through the
outboard lap strap crinkle washer, and
through the bush. Ensure the smaller
diameter of the bush is closest to the bolt
head. Insert the bolt in the threaded boss
and tighten to 48 Nm refer to Figure 145.
Ensure lap strap buckle is uppermost.
NOTE
Use of a longer bolt to secure the outer
lap strap will result in damage to outer
body side panel.
Figure 144: Outboard lap strap
To fit the inboard lap strap, assemble
a 7/16" UNF x 1" bolt, with a plain washer
next to the bolt head, pass through the
inboard lap strap, crinkle washer, and
through the bush. Ensure the smaller
diameter of the bush is closest to the bolt
head. Insert the bolt into the threaded
boss and tighten to 47 Nm, refer to
Figure 146. Ensure lap strap buckle is
uppermost.
Figure 145: Lap straps
10.10) Six point harness
Comments to this Manuals