Caterham Seven User Manual download pdf (Page 156)

Page | 155

Stick masking tape to the underside of the

carpet in the approximate position of the

floor mounted poppers and lay the carpet

into position. Press down firmly on the

carpet so that the bases make an

impression on the masking tape. Make

appropriate holes in the carpet and rivet

together the popper (3) and fastener

button (4), using the Durable Dot

fastening tool, refer to Table 1. Ensure

that the fastener button is uppermost on

the carpet.

NOTE

For correct use of the popper fastener tool

refer to weather equipment section.

Fit the footwell mats into place and secure

using the poppers.

10.6) Boot carpet

The boot carpet is laid into position and

requires no adhesive. It will be necessary

to cut the carpet to fit around the fuel filler

pipe. Tuck the edges of boot carpet down

the sides of the aluminium honeycomb

bootboard at the rear and the sides taking

care not to damage the aluminium body

panel.

The boot carpet also covers the boot

interior side and front panels. Apply

adhesive and secure the carpet shape

into the relevant space.

Fit the fuel filler cover plate into position

and drill through the cover plate into the

boot board using a 2 mm drill. Attach the

cover plate using self-tapping screws

(fastener pack ZCH01 Item 7). It may be

necessary to relocate the fuel filler hose

clips to fit the cover.

10.7) Side and knee trim panels

NOTES

1. If specified, the optional sill protectors

and roll cage must be fitted before the

installation of the knee trim panels, side

panels and associated piping can be

completed.

2. If specified, optional Arm rest bracket

(escutcheon bracket) must be fitted with

side panel/sill protectors (sill protectors

are optional).

Not all of the rivets used to secure the

interior side panels into place will have

been fitted. This is to allow fitting of sill

protectors and to provide access to the

front roll cage mountings, if required.

Warning

When drilling the sill protectors take

care not to drill through both sides of

the chassis tube.

If necessary, position the sill protector on

the sill, with the long edge between the

chassis tube and trim panel, press down

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 226 227

Comments to this Manuals

No comments