Caterham Seven User Manual download pdf (Page 126)

Page | 125

NOTES

1. For a neater appearance position the

clips with the drive screw towards the

ground so that the clip ‘tail’ is out of sight

beneath the exhaust.

2. To reduce the risk of damage it is

advisable to fit the silencer after the RH

rear wing has been attached.

Figure 104: Exhaust arrangement

1. Silencer bracket

3. Lambda probe

2. Band clamp

Loosely fit the single band clamp to the

front of the silencer and position the front

of the silencer over the collector/catalyst

outlet pipe. Locate the bracket at the rear

of the silence over the bobbin on the

silencer mounting bracket and secure with

a nut and spring washer. Tighten the nut

and band clamp. It may be necessary to

reposition the guards slightly.

7.3.7) Cooling system and dry sump

system

The oil tank should be fixed to the chassis

rail intersection point with an M8x20 cap-

head bolt using an M8 spring washer and

an M8 plain washer. Position the breather

bottle mounting bracket on the chassis as

shown in the picture. Align the RHS hole

on the bracket with the RHS rivet on the

chassis and mark both hole. Drill the

marked hole with 5/32” drill and fit the

bracket in place using 5/32 rivets refer to

Figure106. Push fit the breather bottle on

to the mounting bracket.

Figure 105: Fitment of dry sump oil

tank

Two P-clips should then be placed around

the bottom chassis rails and secured to

the bottom of the oil tank with two M6x20

bolts and two M6 nyloc nuts using ¼”

plain washers under the bolt heads and

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 226 227

Comments to this Manuals

No comments