Caterham Seven User Manual Page 147

  • Download
  • Add to my manuals
  • Print
  • Page
    / 227
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 146
Page | 146
2. The holes in the ears are not
symmetrical and therefore will ensure
correct orientation.
Figure 131: De Dion tube end (LH)
1. Brake calliper
9. Bolt
2. Spacer
10. Hub carrier
3. Nyloc nut
11. Bolt
4. Plain washer
12. Rear disc/flange
assembly
5. Spring washer
6. Bolt
13. Thrust washer
7. De Dion tube
14. Nyloc nut (41mm)
8. De Dion ear
15. Driveshaft
Apply Loctite to the threads of bolt
(fastener pack 30Z1067A Item 6) and bolt
the ears into place using spring washers
(20) and plain washers (18) into the
threaded holes at the rear of the De Dion
tube.
Locate the rear hub carrier, with the
rounded edge of the flange uppermost.
Carefully slide the hub over the end of the
driveshaft taking care not to damage
bearings or seals. Bolt the hubs to the ear
by passing the two bolts (3) through the
rear holes of the hub, the centre holes in
the ear and the front holes in the De Dion
tube and tighten into place with the
nylocnuts (7). No washers are required
on these bolts.
Secure the hub to the ear via the forward
holes passing the two bolts (4) through
the hub and ear then securing into place
with plain washers (16) and nyloc nut (7).
NOTES
All cars come with 2 rear ARB
brackets.
Academy cars only come with the right
hand one for the speed sensor
The speed sensor also needs to be
mounted on the ARB bracket Refer figure
133.
Page view 146
1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 226 227

Comments to this Manuals

No comments