Page | 91
Figure 59: Heater valve arrangement
Remove and retain the locknut and
washer from the heater control cable and
pass it from inside the cockpit, through the
hole in the front face of the scuttle, refer to
Figs 60 and 61. Secure the cable in place
using the locknut and washer provided.
Figure 60: Heater control location
Figure 61: Heater control cable
Connect the other end to the heater
control valve by sliding the eyelet on the
inner cable over the peg on the heater
valve operating arm then slide the outer
cable under the adjacent clamp and
tighten the screw to secure in place, refer
to Figure 62. Ensure that the valve travels
through its full range when operated from
inside the car. This can be adjusted by
slackening the clamp that locates the
outer cable to the valve and sliding the
cable one way or another.
Comments to this Manuals