Caterham Seven User Manual download pdf (Page 181)

Page | 180

13.6) Boot cover

When correctly fitted, the boot cover

should be as shown in Figure 167.

Figure 166: Boot cover

The boot cover is designed to attach

permanently to the top of the bulkhead

behind the seat and clip onto the same

fasteners as those provided for the hood

at the rear of the car. It is designed to fit

over the hoodsticks when not in use

therefore it is essential that these are

fitted prior to fitting the boot cover. When

the hood is erected, the boot cover is

folded away and stored in the boot.

The boot cover is designed to fit around

the roll bar, since these vary according to

specification, ensure the correct boot

cover has been supplied. There is a

special boot cover designed for use with

the roll cage.

NOTE

For cars fitted with harness type seat belts

go to ‘Note’ in Boot cover section.

All boot covers have a metal insert along

the forward edge, with pre-drilled holes to

locate the fastener bases. The forward

edge of the boot cover should align with

the front edge of the seat bulkhead.

Ensure that the boot cover is centrally

located and mark the holes through the

forward edge of the boot cover. Drill a

7/64” hole through each marked location

and fit a popper base (fastener pack

ZBC02 Item 5) secured with a self-tapping

screw (6).

If harness type seat belts are being fitted

the metal insert in the boot cover must be

removed. Align the boot cover as

previously described and mark the

location of the four threaded bosses.

Punch a hole in each of the marked

locations and fit the harness shoulder

strap securing bolts through the boot

cover.

Additionally fit four fasteners (5) using

screws (6) in the following locations; one

fastener 1 1/4" either side of the car

centreline and one fastener at the

midpoint between each pair of shoulder

restrains. If a tonneau cover is to be

fitted, the position of the fasteners will

have to be adjusted accordingly.

Stretch the boot cover over the luggage

area. Secure around the rear stays of the

roll over bar using the Velcro and

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 226 227

Comments to this Manuals

No comments