Caterham Seven User Manual Page 214

  • Download
  • Add to my manuals
  • Print
  • Page
    / 227
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 213
Page | 213
Figure 187: Filler cover and boot carpet
removed
Warning
Wear appropriate eye protection whilst
carrying out drilling operations.
Remove the old cap with the the key and
block the filler hole with tape or cloth.
Remove the two self-tapping screws that
retain the top of the filler neck to the filler
boss, the rubber hoses will then allow the
filler neck to be pulled out of the way.
Drill out the six rivets that retain the old
filler boss. This must be done very
carefully to avoid damage to the back
panel. It is recommended this is done with
a hand or air drill to eliminate the sparks
caused by an electric drill.
Figure 188: Drill out the six rivets
The old filler boss can then be carefully
pulled away from the back panel.
Figure 189: Old filler boss removed
Take the gasket supplied with the kit and
carefully align the hole in the gasket with
the hole in the back panel. Ensure two of
the fixing holes are positioned at 3 o’clock
and 9 o’clock.
Figure 190: Gasket positioned on back
panel
Mark the new hole positions and carefully
centre punch the marks. Taking great
care, drill the holes (6 mm diameter).
Figure 191: Carefully drill new holes
Fit the black spacer to the filler neck using
the two M5 cap head screws supplied in
the kit. The spacer will be a tight fit on the
Page view 213
1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 226 227

Comments to this Manuals

No comments