Caterham Seven User Manual download pdf (Page 162)

Page | 161

If the car has a honeycomb floor, bolt (1)

is passed through the runner, through

spacer (6) and secured using plain

washer (5) and nyloc nut (4).

Figure 148: Composite seat and six-

point harness

1. Composite seat

2. Six-point harness

3. Seat adjuster

10.11.2.1) Fixed seat

The fixed seat is bolted to the floor via

two 25 mm square section, aluminium

tubes. This tube has a series of cut-outs

on one side and plain holes in the

opposite side. It is important that this tube

is fitted in the correct orientation. The cut-

outs must face away from the seat base

allowing flush fitment to the floor. The

large cut-out must be biased towards the

rear of the seat. Both tubes are identical

and are fitted in the same orientation,

refer to Fig 150.

Figure 149: Fixed seat

1. Large recess

2. Spacer

Position the square section aluminium

tubes on the seat base and pass bolt

(fastener pack ZSE05 Item 2) through the

large hole in the underside of the spacer

and into the small hole opposite, through

one thick spacer (8) and into the threaded

seat base. Torque all fixings

to 14 Nm.

NOTE

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 226 227

No comments

Caterham Seven User Manual Page 162