Caterham Seven User Manual Page 216

  • Download
  • Add to my manuals
  • Print
  • Page
    / 227
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 215
Page | 215
17.8) High level brake light
Figure 195: Kit contents for high level
brake light
1. Wiring sub loom
2. Wiring to high level brake light
3. Rivets (x2)
4. Male Lucar terminals and shrouds
5. Nut and plastic bolt from light kit
6. Replacement popper
7. Rubber grommet
8. Sticky pad
9. Cable ties
10. Larger spare wheel boss
11. Cable insulation
12. Light support bracket
13. High level brake light
17.8.1) Fitting the bracket
If retro-fitting, the spare wheel must first
be removed from the car.
Working from inside the boot, unscrew
the 5/8” nut which holds the spare wheel
boss to the back panel, and remove the
boss, taking care not to drop the large
washers.
Warning
Wear eye protection when carrying out
drilling operations.
Centre mark a point 25 mm below the top
of the back panel, on the vehicle centre
line. Centre punch this, and drill a 5/32”
hole, taking care not to damage the back
panel. In the case of the SV, simply
remove the central hood/boot cover
popper using a 5/32" drill, as shown in
Figure 198.
Figure 196: Drilling central popper on
SV
Using masking tape to protect the
paintwork from damage, position the
bracket as shown in Fig 199, passing the
new, larger spare wheel boss through the
bracket and back panel, ensuring only one
large washer is used in between the back
panel and spare wheel support channel.
Secure the boss using the 5/32” nut,
finger tight only.
Page view 215
1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 226 227

Comments to this Manuals

No comments