Caterham Seven User Manual download pdf (Page 218)

Page | 217

filler neck cover, and remove it. From

under the right and rear corner of the car,

feed the terminated end of the supplied

sub-loom up into the boot area, through

the hole exposed by removing the filler

neck cover. Disconnect the wiring plugs

leading to the rear light cluster, and

connect the plugs from the sub loom in

between, as shown in Fig 201.

Figure 200: View from under RHS rear

corner

Re-assemble the light unit, and feed the

cable insulation over the wires. Push

them through the hole in the sticky pad

and the hole in the platform on the

bracket, then use the sticky pad to fix the

light in place, shown in Fig 202. Feed the

wires down through the RH support tube

of the bracket, then through the rubber

grommet into the boot area, shown in

Fig 203.

Figure 201: Exploded view of assembly

Cut the wires from the light unit to length

so the connections can be concealed

behind the filler neck cover, and terminate

with the male Lucar terminals and

shrouds. Connect these to the sub-loom;

grey/red to the green/purple, and grey to

the black wire. Use the cable ties

provided to tidy and secure the wiring, and

re-fit the filler neck cover.

Figure 202: Wires from support tube

entering boot

Reconnect the battery, and with the aid of

an assistant, check to ensure that the

high-level brake light operates in

conjunction with the brake lights in the

rear clusters, and re-fit the spare wheel.

The completed assembly is shown in Fig

204.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 226 227

Comments to this Manuals

No comments