Caterham Seven User Manual download pdf (Page 177)

Page | 176

hoodstick as this will ensure that it is

correctly adjusted.

The front popper base for the side of the

hood can now be fitted. To do this pull the

side of the hood down and assess the

approximate position for the popper base.

Apply several layers of masking tape to

this area.

Pull the side of the hood down again and

press on the fastener to create an imprint

in the masking tape. Drill a 3/32” hole

through the centre of the impression,

remove the tape and secure a popper

base using a self-tapping screw.

NOTE

Care should be taken while drilling hole on

curve of the chassis tube.

Repeat the above procedure for the

remaining popper bases along the cockpit

and boot sides, refer to Figure 161.

Figure 160: Hood side fasteners

1. Hoodstick

2. Popper base

3. Rear wing

13.3) Sidescreen fitment

Using the setscrews (5) and nyloc

nuts (13) attach the sidescreen hinges to

the outside of the windscreen stanchions

with the eyelet towards the rear of the car,

refer to Fig 162. Fit the brass hinge

pins (8) into the 4 remaining hinges. Now

slide the hinges with the pins fitted into the

top of hinges attached to the car.

NOTE

SV sidescreens hinges are now supplied

with pre-fitted hinge pins.

Figure 161: Hinge and side screen

fitting

1. Windscreen stanchions

2. Sidescreen hinges

The sidescreen is constructed using a

steel frame around the window section.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 226 227

Comments to this Manuals

No comments