Caterham Seven User Manual download pdf (Page 84)

Page | 83

banjo bolt and pass the banjo bolt through

the union at the end of the hose, refer to

Fig 46. Fit the second copper washer to

the banjo bolt and screw the banjo bolt

into the clutch master cylinder outlet port

(remove the port plug). Do not fully tighten

the banjo bolt.

Figure 46: Clutch master cylinder hose

union

1. Banjo bolt

3. Hose union

2. Copper washers

4. Clutch master

cylinder

Route the hose down the side of the pedal

box, over the wiring loom (under the

heater hose if fitted) and across the top of

the bell-housing, Refer to Figure 47. Push

the end of the hose into the connector in

the clutch release bearing assembly and

ensure that the hose is firmly attached.

Secure the hose with cable ties if

necessary, to prevent chafing and tighten

the banjo bolt (the clutch system is filled

and bled during start-up/final checks.

Figure 47: Clutch hydraulic hose

7.1.6) Exhaust systems

The standard exhaust system consists of

four primary pipes, a collector assembly

which also incorporates the catalytic

converter and a one piece silencer and tail

pipe.

Bolt the exhaust mounting bracket

(polythene bag marked 'exhaust') to the

RH side of the car forward of the rear

wheel, using setscrew (fastener pack

30X020A Item 1) and spring washers (3),

refer to Figure 48. Secure the bobbin to

the angle bracket with a nut (2) and spring

washer (3).

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 226 227

Comments to this Manuals

No comments